GENERAL INSTRUCTIONS:

1. Protect work surface with disposable paper.
2. Shake 505 Spray & Fix can before using.
3. Hold can 12 in. / 30 cm. from fabric surface.
4. Always spray 505 Spray& Fix on the wrong side of the smaller fabric piece to be glued.
5. A light spray of 505 Spray& Fix is sufficient. A little goes a long way.
6. Using your hand, press firmly in place to secure the piece to the larger fabric.
7. A misaligned piece may be removed and repositioned several times for 15 to 20 minutes after spraying.
8. Machine sew in place as usual.
9. Cleanup with soap and water.
10. Read label on can for storage, disposal, and first aid.
11. Test on all fabrics before using.

SEWING:

1. Read general instructions.
2. Place fabric pattern on protected surface, opposite how your pattern's layout is shown.





3. Spray pattern lightly with 202. Turn over and position on your fabric. Secure in place by pressing by hand to smooth pattern flat to fabric.





4. Cut around pattern.
5. Peel up pattern to transfer pattern markings. Use a warm iron to re-activate glue and re-stick pattern in place.
6. When ready to assemble, remove pattern and return to envelope.
7. Machine sew garment.
8. When using pattern a second time, just position in place and re-activate glue with a warm iron. No need to re-spray.

BASTING:

Work one half of the quilt at a time.

1. Read general instructions.
2. Roll top back to the 1/2 way point.





3. Spray backing in 1 foot intervals for better control.





4. Press batting in place by hand, then spray batting in 1 foot intervals.





5. Press top in place by hand.
6. Repeat on opposite half of layered quilt.

QUILTING:

1. Read general instructions.
2. Choose your continuous quilting pattern. Use channel cut plastic stencils or patterns traced onto tracing paper.
3. Lightly spray back of plastic stencil pattern and trace on fabric, or spray back edges of paper patterns on tracing paper.





4. Position on top of layered quilt.





5. Machine quilt.





6. Remove pattern.

EMBROIDERY:

1. Read general instructions.
2. Lightly spray 505 on the stabilizing interfacing.





3. Position interfacing behind the area to be embroidered.
4. Using your hand, press in place to secure.
5. Embroider your pattern.





6. Remove excess interfacing if needed.

APPLIQUE:

1. Read general instructions
2. Draw shape on paper.





3. Cut out shape and spray 505 lightly on paper shape.





4. Place on fabric using the pressure from your hand to secure in place.





5. Cut around paper shape.
6. Separate the fabric from the paper.





7. Spray 505 on the wrong side of the applique shape.
8. Arrange applique shapes on background fabric. Press in place by hand.





9. Reposition if needed.

CELTIC APPLIQUE & STAINED GLASS APPLIQUE:

1. Read general instructions.
2. Prepare your bias fabric strip with the seam pressed at the back center of the strip.





3. Place the bias strip on a protected surface and spray evenly.
4. Trace pattern on a background fabric.





5. Follow pattern with the 505 sprayed bias tape making sure to begin and end where the pattern crosses over itself. Press by hand to secure in place.





6. Machine or hand sew in place.

FREEZER PAPER APPLIQUE:

1. Read general instructions.
2. Cut out shape from freezer paper or regular paper.





3. Cut out fabric 1/4" larger than paper pattern. If using freezer paper, iron in place. If using regular paper, spray with 505.





4. Clip curves if needed.





5. On a protected surface spray the shape with 505 evenly. Finger press the seam allowance to the paper then position on background fabric.
6. Sew in place by hand or machine.